ECO-FRIENDLY
NHOU® MARINE CORROSION GUARD
NHOU Enviro / Marine Corrosion Guard is a rust inhibitor oil that forms a water-displacing, moisture-resistant, non-conductive barrier on non-painted and painted surfaces. Marine protective coatings prevent rust from forming on outdrives, lower units and power trim motors and components or other metal surfaces.
Protect Your Boat from Rust!
- Displaces moisture and forms a barrier against airborne chemicals to protect against rust and corrosion
- Forms a nonconductive water-resistant barrier for added protection from marine environments
- Remains clear and doesn’t peel
- Marine rust inhibitor is safe for all painted surfaces
- Do not spray on surfaces coated with antifouling or biocide paint. Do not spray on drive belts or soft natural rubber
How to Apply NH Marine Corrosion Guard
- Remove all dirt, wax, grease, saltwater deposits, and other contaminants with a high-quality cleaner.
- Rinse with water and allow the area to dry.
- Shake can vigorously for one minute after mixing ball begins to rattle.
- Hold the can upright 6-10″ from the surface and apply thin, even coats using a steady back-and-forth motion.
- Note: Keep the can in motion while spraying; release the button after each stroke.
- Reapply before storing your boat and every week if boating in saltwater areas.
When finished spraying, clear the spray valve by turning the can upside down and pushing the spray button until clear gas comes out. Clean up wet paint with simple green or dish soap. Dispose of empty cans in accordance with local, state, and federal regulations.
*Not available to California residents
Book Your Appointment Today!
NHOU® Mil-Spec Hybrid is typically applied to vehicles less than three years old.